Engine Performance And Smoke Emission Tests Of Transesterified Swietenia macrophylla King (Philippine Broad-Leaved Mahogany) Seed Oil

https://doi.org/10.22146/ajche.49550

Jeremy James E. Ogilvie(1), Claudette Miracel R. Oñate(2), Gemarie Hazel F. Quetua(3), Maria Natalia R. Dimaano(4*)

(1) Chemical Engineering Department, Faculty of Engineering, University of Santo Tomas, España, Manila, Philippines
(2) Chemical Engineering Department, Faculty of Engineering, University of Santo Tomas, España, Manila, Philippines
(3) Chemical Engineering Department, Faculty of Engineering, University of Santo Tomas, España, Manila, Philippines
(4) Chemical Engineering Department, Faculty of Engineering, University of Santo Tomas, España, Manila, Philippines; Research Center for the Natural and Applied Sciences, University of Santo Tomas, España, Manila, Philippines
(*) Corresponding Author

Abstract


Biodiesel is the most common alternative fuel that can be used in diesel engines. Commercially 2% of coco methyl ester (CME) as biodiesel is blended with petroleum based diesel and is used as fuel. Exhaust emissions are improved using the biodiesel blends. This study is devoted to the engine performance test of diesel engine as affected by Mahogany Methyl Ester (MhME). The MhME was produced by extracting the oil of the mahogany seeds by solvent extraction using petroleum ether. Sulfuric acid catalyzed esterification and potassium hydroxide- catalyzed transesterification were used for the MhME production. The fuel properties of the B5 and B50 biodiesel blends were determined. The kinematic viscosities of B5 and B50 were reported as 3.21, and 3.63 mm2/sec, respectively. The engine performance test was done on a Gunt Hamburg CT 110 Four-Stroke Diesel Engine. Results showed that B5 MhME obtained the highest power and highest torque at full fuel load. For the fuel consumption, pure commercial diesel was observed to have the lowest at 2500 and at 2750 rpm. In addition, B50 MhME emits less CO2, CO, hydrocarbon and O2.

Keywords


hybrid coal, co–pyrolysis, low rank coal, biomass waste

Full Text:

PDF


References

  1. O.S. Stmenkovic, I.B. Bankovic-llic, V.B. Veljkovic, Renew. Sust. Egy. Revs, 3621-2467 (2012)
  2. K.V. Caguimbal, D.M. Lastimoso, C. Navarette, M.N.R. Dimaano, RSCE 2015 Proceedings, IN-ENG-033 (2015)
  3. J. MacFarlene, JM Science (2008)
  4. T.E. Grift, A.C. Hansen, J. Xue, Renew. Sust. Egy. Revs, 15,2, 1098-1116 (2011)
  5. Y. Bian, H. Chen, L. Geng, J. Liu, D.H. Qi, Ren. Egy., 34, 12, 2706-2713 (2009).



DOI: https://doi.org/10.22146/ajche.49550

Article Metrics

Abstract views : 1190 | views : 716

Refbacks

  • There are currently no refbacks.


ASEAN Journal of Chemical Engineering  (print ISSN 1655-4418; online ISSN 2655-5409) is published by Chemical Engineering Department, Faculty of Engineering, Universitas Gadjah Mada.