Use of the Taguchi Design of Experiments to Optimize the Parameters of Cleaning Machines for Sensitive Plastic Products

https://doi.org/10.22146/ajche.50808

Sherwin Celestino(1*), Joseph Auresenla(2)

(1) Department of Chemical Engineering De La Salle University 2401 Taft Avenue 1004 Manila, Philippines Tel: 63-2-524-4611 local 222
(2) Department of Chemical Engineering De La Salle University 2401 Taft Avenue 1004 Manila, Philippines Tel: 63-2-524-4611 local 222
(*) Corresponding Author

Abstract


The Taguchi Design of Experiments (DOE), an optimization technique, was used to establish stabilized operating parameter settings for an ultrasonic cleaning machine for a new and very dirt sensitive plastic product referred to as type A plastic produced in a company in the Philippines. The optimization process is done in actual industrial setting. Taguchi DOE defined quality as minimum variation around the target specification of a product. The matrix used for the project is the La 27 orthogonal array wherein the experiment is comprised of eight runs with seven maximum possible factors at two levels. After each experimental run, the percentage ejection rate was monitored as the measurable characteristic of the finished product. Since rejection rate was the parameter used, the ultimate value closer to zero is better (the smaller the better). Confirmation runs showed that the percentage of rejection rate has improved from 62% to 17% when the established optimized machine parameters were used. Moreover, production yield has increased from 75% to more than 90% for product type A.



References

  1. Taguchi, Dr. Genichi. Taguchi Methods (Case Studies from the U.S. and Europe). ASI Press, Michigan, 1989, pp. 57-72.
  2. Celestino, Sherwin D.G., et al. Process Optimization for Multiple Plating ThicknessRequirements:ACaseStudy for Dynamic Parameter Design. ASEMEP Proceedings, 1999.
  3. Walpole, Ronald E. and Myers, Raymond H. Probability and Statistics for Engineers and_Scientists. Macmillan Publishing Company, New York, 1985.
  4. Ealey, Lance A. Quality By Design (Taguchi Methods in U.S. Industry). ASI Press, Michigan, 1988, pp. 293-299.
  5. Fuchs,John E PrecisionCleaning'94 Proceedings (May16-18, 1994- RosemontConvention Center). WitterPublishingCo., Inc., 1994, 212-224.
  6. The Textwipe Company Inc. Contamination Control Products for the Microelectronics Industryand CriticalManufacturing. 1999 pp. 36-38.



DOI: https://doi.org/10.22146/ajche.50808

Article Metrics

Abstract views : 19

Refbacks

  • There are currently no refbacks.