Simulasi dan Analisis Sistem Pengatur Tegangan DC Menggunakan Rangkaian Push-Pull Converter

  • Feri Yusivar Universitas Indonesia
  • Lintang Hapsari Wilujeng Universitas Indonesia
Keywords: Tegangan DC, Push-Pull Converter, eknik Pensaklaran, Pengendali PI, Pengendali IP

Abstract

A problem that often encountered in sources voltage especially DC (Direct Current) voltage sources are far below the working voltage levels that are generally used in residential electrical grid system. To handling the problems of the DC voltage source, one way that can be taken is to implement a DC voltage converter circuit or DC-DC Converter.
In this paper, a series of isolated type DC-DC Converters, namely Push-Pull Converter, is being promoted. The Selection of Push-Pull Converter based on reliability and quality of generated power among others, ease of applicability and the most important is the robustness of the interference that may occur.
The system is controlled by a simple linear controller, such as Proportional Integral (PI) controller or Integral Proportional (IP) controller. System’s stability is also tested using Bode plots. From simulation results and stability analysis, it can be conclude that the Push-Pull converter circuit resists against disturbance.

References

Guerrero, Joseph M., Kai Sun, Li Zing, Yan Xing. (2011). A Distributed Control Strategy Based on DC Bus Signaling for Modular Photovoltaic Generation Systems with Battery nergy Storage. IEEE: IEEE Transactions on Power Electronics Vol. 26 No. 10.

T.Patarau, D.Petreus, S.R. Daraban, R.A. Munteanu, D. Moga, A. Rusu. (2011). Analysis And Design Of A Bidirectional Dc-Dcconverter With Current Doubler Rectifier Used In Smart Grid. IEEE: Acemp – Electromotion.

Patarau, Toma., Petreus, Dorin., Etz, Radu., Cirstea, Marcian., Daraban, Stefan. (2012). Digital control of bidirectional DC-DC converters in Smart Grids. IEEE.

Pekik, Wulandari. (2004). Perbaikan Kinerja Pengendali Arus Keluaran Konverter Daya dengan Menggunakan Induktor Virtual. Politeknik Negeri Surabaya: IES.

Erickson, Robert W., Maksimovic, Dragan. (2001). Fundamentals of Power Electronics Second Edition. The Netherlands: Kluwer Academic Publishers.

Argo Dahono, Pekik (2010). Bahan Ajar Elektronika Daya: Konverter DC-DC. Bandung: ITB.

Hart, Daniel W. (1997). Introduction to Power Electronics (International Edition). Indiana: Prentice Hall International Edition.

Nise, Norman S. (2003). Control System Engineering 4th Edition. Wiley.

F I Ahmed, A M El-Tobshy, A A Mahfouz, andM M Ibrahim. (1998). (I-P) Adaptive Controller for DC Motor Drives: A Hardware and Software Approach.UKACC International Conference on CONTROL, Conference Publication No. 455, IEE.

How to Cite
Feri Yusivar, & Lintang Hapsari Wilujeng. (1). Simulasi dan Analisis Sistem Pengatur Tegangan DC Menggunakan Rangkaian Push-Pull Converter. Jurnal Nasional Teknik Elektro Dan Teknologi Informasi, 3(4), 287-294. Retrieved from https://journal.ugm.ac.id/v3/JNTETI/article/view/3050
Section
Articles