Anionic Dye Adsorption from Aqueous Solutions by Chitosan Coated Luffa Fibers

https://doi.org/10.22146/ajche.49534

Cherdphong Seedao(1*), Tanawat Rachphirom(2), Methinee Phiromchoei(3), Witawat Jangiam(4)

(1) Department of Chemical Engineering, Faculty of Engineering, Burapha University, Chonburi 20131, Thailand
(2) Department of Chemical Engineering, Faculty of Engineering, Burapha University, Chonburi 20131, Thailand
(3) Department of Chemical Engineering, Faculty of Engineering, Burapha University, Chonburi 20131, Thailand
(4) Department of Chemical Engineering, Faculty of Engineering, Burapha University, Chonburi 20131, Thailand
(*) Corresponding Author

Abstract


Chitosan (CS) is biopolymer derived from deacetylation of chitin which can be found mainly in crustacean shells such as shrimp, crab, lobster etc. CS powder has been used to remove dye in many research. However, it was difficult to separate CS powder from aqueous solution. Considering the three-dimensional sponge natural structure of luffa fiber. it may address this issue by coating CS onto the surface of luffa fiber. This adsorbent was called chitosan coated luffa fiber (CS-LF). The aim of this studied is to investigate the potential of CS-LF to remove the anionic dye. Congo red is representative of anionic dye. Adsorption of anionic dye from aqueous solution using CS-LF was studied in a batch system. The effect of chitosan concentration coated on luffa fiber and initial anionic dye concentrations had been investigated on adsorption equilibrium and adsorption kinetic. An adsorption isotherm data were regularly analyzed using Langmuir and Freundlich isotherm models. While, adsorption kinetic were basically evaluated by pseudo-first-order, pseudo-second-order and intraparticle diffusion equation. The results showed that the adsorption isotherm fitted well by Langmuir isotherm model with maximum adsorption capacity 20.37 mg/g. The anionic dye adsorption kinetic of CS-LF were greatest described by pseudo-second-order equation and rate-controlling step of anionic dye adsorption process may be chemical reaction. Therefore, CS-LF is potential adsorbent as low-cost adsorbent to remove anionic dye from aqueous solution and could be simply separated from aqueous solutions after used. Finally, our study is firstly report in anionic dye adsorption using chitosan coated luffa fiber.

Keywords


Adsorption, Chitosan, Luffa Fibers, Congo Red, Anionic Dye

Full Text:

PDF


References

  1. Q.H. Hu, S.Z. Qiao, F. Haghseresht, M.A. Wilson,  G.Q.  Lu, Adsorption  study  for removal of basic red dye using bentonite, Ind. Eng. Chem. Res. 45, 733–738 (2006)
  2. S. Wong, N.A.N. Yac’cob, N. Ngadi, O. Hassan, I.M. Inuwa, From Pollutant to Solution  of  Wastewater  Pollution: Synthesis  of  Activated  Carbon  from Textile  Sludge  for  Dyes  Adsorption, Chinese  J.  Chem.  Eng.  (2017).(to  be published)
  3. S.S.  Salih,  T.K.  Ghosh, Adsorption  of Zn(II)   ions   by   chitosan   coated diatomaceous  earth,  Int.  J.  Biol. Macromol. (2017). (to be published)
  4. M. Ferhat, S. Kadouche, N. Drouiche, K. Messaoudi,  B.  Messaoudi,  H.  Lounici, Competitive adsorption of toxic metals on  bentonite  and  use  of  chitosan  as flocculent  coagulant  to  speed  up  the settling of generated clay suspensions, Chemosphere. 165, 87–93 (2016).
  5. J.  Xie,  C.  Li,  L.  Chi,  D.  Wu, Chitosan modified zeolite as a versatile adsorbent for the removal of different pollutants from water,Fuel. 103, 480–485. (2013)
  6. J.Y. Farah, N.S. El-Gendy, L.A. Farahat, Biosorption of Astrazone Blue basic dye from an aqueous solution using dried biomass  of  Baker’s  yeast,  J.  Hazard. Mater. 148(2007) 402–408.
  7. G.Z. Kyzas, K.A. Matis, Nanoadsorbents for pollutants removal: A review, J. Mol. Liq. 203, 159–168 (2015)
  8. Kinetics, isotherms and thermodynamic modeling of liquid phase adsorption of Rhodamine B dye onto Raphia hookerie fruit epicarp, Water Resour. Ind. 15, 14–27 (2016).
  9. Y.C. Wong, Y.S. Szeto, W.H. Cheung, G. McKay, Equilibrium studies for acid dye adsorption onto chitosan, Langmuir. 19, 7888–7894 (2003)
  10. T.W. Weber, R.K. Chakravorti, Pore and solid  diffusion  models  for  fixed???bed adsorbers, AIChE J. 20, 228–238 (1974)
  11. B. Liao, W. Sun, N. Guo, S. Ding, S. Su, Equilibriums  and  kinetics  studies  for adsorption of Ni(II) ion on chitosan and its   triethylenetetramine   derivative, Colloids Surfaces A Physicochem. Eng. Asp. 501, 32–41(2016)
  12. X. Tang, Q. Zhang, Z. Liu, K. Pan, Y. Dong, Y. Li, Removal of Cu(II) by loofah fibers as  a  natural  and  low-cost  adsorbent from aqueous solutions,J. Mol. Liq. 199, 401–407 (2014).
  13. F.  Rozada, Dye adsorption by sewage sludge-based activated carbons in batch and  fixed-bed  systems,  Bioresour. Technol. 87, 221–230. (2003) 



DOI: https://doi.org/10.22146/ajche.49534

Article Metrics

Abstract views : 56 | views : 36

Refbacks

  • There are currently no refbacks.