PREPARATION AND CATALYTIC ACTIVITY FOR ISOPROPYL BENZENE CRACKING OF Co, Mo AND Co/Mo-Al2O3-PILLARED MONTMORILLONITE CATALYSTS
Hasanudin Hasanudin(1*), Karna Wijaya(2), Budi Santoso(3)
(1) Department of Chemistry, Faculty of Mathematics and Natural Sciences, Sriwijaya University, Inderalaya, Palembang 30662, Indonesia
(2) Department of Chemistry, Faculty of Mathematics and Natural Sciences, Gadjah Mada University, Sekip Utara, Yogyakarta 55281, Indonesia
(3) Department of Chemical Engineering, Faculty of Engineering, Sriwijaya University, Inderalaya, Palembang 30662, Indonesia
(*) Corresponding Author
Abstract
It has been prepared Co, Mo and Co/Mo-Al2O3-pillared montmorillonite catalysts using montmorillonite clay as raw material. The structure and porosity of the catalysts were determined using N2 adsorption-desorption and FT-IR spectroscopy analysis methods. Isopropyl benzene cracking using these catalysts were used to test the catalytic activity and performance of Co, Mo and Co/Mo-Al2O3-pillared montmorillonites. Characterization results showed that pillarization resulted in the increase of the total pore volume and specific surface area of the clay. Meanwhile, transition metals (Co, Mo and Co/Mo) loaded on Al2O3-pillared monmorillonites could increase the catalytic activity of the catalysts for isopropyl benzene cracking significantly.
Keywords
Full Text:
Full Text PDFReferences
[1] Brindley. G.W., and Sempels, R.E., 1977, Clays Clay Miner., 12, 229.
[2] Yang R.T., 1999, J. Chem. Soc., Faraday Trans., 82, 3081.
[3] Yuan, P., Hongping, H., Bergaya, F., Wu, D., Zhou, Q., and Zhu, J., 2005, 88, Microporous Mesoporous Mater., 88, 8.
[4] Yahiaoui, A., Belbachir, M., and Hachemaoui, A., 2003, Int. J. Mol. Sci., 2003, 4, 548.
[5] Fripiat, J.J., Gastuche, M.C., and Richard, R.B., 1962, J. Phys. Chem., 66, 806.
[6] Burch, R., 1987. Introduction. Catal. Today, 2, 185.
[7] Figueras, F., 1988, Cat. Rev. - Sci. Eng., 30, 457.
[8] Lambert, J.F., and Poncelet, G., 1997, Top. Catal., 4, 43.
[9] Salermo, P., Mendioroz, S., and Agudo, A.L., 2003, Appl. Clay. Sci., 23, 287.
[10] Salermo, P., Mendioroz, S., and Agudo, A.L., 2004, Appl. Catal., A., 259, 17.
[11] Wang, S., Zhu, H.Y., and Lu, G.M.Q., 1998, J. Colloid Interface Sci., 204, 128.
[12] Hasanudin, Wijaya, K., Rachmat, A., and Trisunaryanti, W., 2008, J. Penelitian Sains, 11, 2, 481.
[13] Poppl, L., Toth, E., Toth, M., Pasli, I., Izvekov, V., and Gabor, M., 1998, J. Therm. Anal., 53, 585.
[14] Brunauer, S., Demming, L.S., Demming, W.S., and Teller, E.J., 1940, J. Am. Chem. Soc., 62, 1723.
[15] Lowell, S., and Shields, J.E., 1984, Powder Surface Area and Porosity, Chapman and Hall, New York, 59.
[16] Swarnakar, R., Brandt, K.B., and Kydd, R.A., 1996, Appl. Catal., A., 142, 61.
DOI: https://doi.org/10.22146/ijc.21528
Article Metrics
Abstract views : 1873 | views : 2067Copyright (c) 2010 Indonesian Journal of Chemistry
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Indonesian Journal of Chemistry (ISSN 1411-9420 /e-ISSN 2460-1578) - Chemistry Department, Universitas Gadjah Mada, Indonesia.
View The Statistics of Indones. J. Chem.