Modified Silica Adsorbent from Volcanic Ash for Cr(VI) Anionic Removal

Endang Tri Wahyuni(1*), Roto Roto(2), Firda Ainun Nissa(3), Mudasir Mudasir(4), Nurul Hidayat Aprilita(5)

(1) Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Sekip Utara, Yogyakarta 55281, Indonesia
(2) Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Sekip Utara, Yogyakarta 55281, Indonesia
(3) Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Sekip Utara, Yogyakarta 55281, Indonesia
(4) Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Sekip Utara, Yogyakarta 55281, Indonesia
(5) Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Sekip Utara, Yogyakarta 55281, Indonesia
(*) Corresponding Author


In the present research, cetyltrymethyl ammonium bromide (CTAB)-modified silica from Kelud’s volcanic ash has been prepared and examined as adsorbent for removal of the hazardous Cr(VI) anion. The research was initiated with purification of SiO2 from the volcanic ash that was carried out by reacting the volcanic ash with NaOH powder at 900 °C for 2 h, followed by dissolving the ash to water at 100 °C, and then was acidified with HCl 1 M to form hydrogel. By calcination of the hydrogel, silica (SiO2) gel was obtained. The next step was modification of the silica with CTAB, that was performed by interacting the CTAB solution with the gel, in which the concentration of the CTAB was varied. Then the CTAB-modified silica samples were characterized by using FTIR, XRD, and SEM machines. The activity of the adsorbent was examined for adsorption of CrO4= in the solution. The results of the research demonstrate that the amorphous silica gel and the amorphous CTAB-modified silica have been obtained. The CTAB-modified silica was found to possess much higher ability in the adsorption of CrO4= anion, that was 48.90 mg/g, compared to that of the unmodified silica gel, as much 5.68 mg/g. These findings strongly prove that the negative surface of the CTAB-modified silica adsorbent has been successfully formed. Furthermore, it is also observed that increasing concentration of CTAB in SiO2-CTA can promote more effective adsorption of the CrO4= from the solution, but the further enlargement of the CTAB concentration leads to the adsorption decreased, and the highest adsorption was shown by CTAB-modified silica prepared with 0.10 mole of CTAB/1 mole SiO2.


volcanic ash; silica; modification; CTAB; adsorbent; Cr(VI)

Full Text:

Full Text PDF


[1] Taylor, H.E., and Lichte, F.E., 1980, Chemical composition of Mount St. Helens volcanic ash, Geophys. Res. Lett., 7 (11), 949–952.

[2] Toscano, G., Caristi, C., and Cimino, G., 2008, Sorption of heavy metal from aqueous solution by volcanic ash, C.R. Chim., 11 (6-7), 765–771.

[3] Sayari, A., Hamoudi, S., and Yang, Y., 2005, Applications of pore-expanded mesoporous silica. 1. Removal of heavy metal cations and organic pollutants from wastewater, Chem. Mater., 17 (1), 212–216.

[4] Parida, S.K., Dash, S., Patel, S., and Mishra, B.K., 2006, Adsorption of organic molecules on silica surface, Adv. Colloid Interface Sci., 121 (1-3), 77–110.

[5] Koner, S., Pal, A., and Adak, A., 2012, Use of surface modified silica gel factory waste for removal of 2,4-D pesticide from agricultural wastewater: A case study, Int. J. Environ. Res., 6 (4), 995–1006.

[6] Sdiri, A., Higashi, T., Bouaziz, S., and Benzina, M., 2014, Synthesis and characterization of silica gel from siliceous sands of Southern Tunisia, Arabian J. Chem., 7 (4), 486–493.

[7] Amin, N., Khattak, S., Noor, S., and Ferroze, I., 2015, Synthesis and characterization of silica from bottom ash of sugar industry, J. Cleaner Prod., 117, 207–211.

[8] Georgieva, V.G., Tavlieva, M.P., Genieva, S.D., and Vlaev, L.T., 2015, Adsorption kinetics of Cr(VI) ions from aqueous solutions onto black rice husk ash, J. Mol. Liq., 208, 219–226.

[9] Le, V.H., Thuc, C.N.H., and Thuc, H.H., 2013, Synthesis of silica nanoparticles from vietnamese rice husk by sol–gel method, Nanoscale Res. Lett., 8 (1), 58–68.

[10] Dinker, M.K., and Kulkarni, P.S., 2015, Recent advances in silica-based materials for the removal of hexavalent chromium: A review, J. Chem. Eng. Data, 60 (9), 2521–2540.

[11] Choppala, G., Bolan, N., and Park, J.H., 2013, Chromium contamination and its risk management in complex environmental settings, Adv. Agron., 120, 129–172.

[12] Mor, S., Ravindra, K., and Bishnoi, N.R., 2007, Adsorption of chromium from aqueous solution by activated alumina and activated charcoal, Bioresour. Technol., 98 (4), 954–957.

[13] Selvi, K., Pattabhi, S., and Kadirvelu, K., 2001, Removal of Cr(VI) from aqueous solution by adsorption onto activated carbon, Bioresour. Technol., 80 (1), 87–89.

[14] Wu, H.X., Wang, T.J., Chen, L., and Jin, Y., 2009, The roles of the surface charge and hydroxyl group on a Fe-Al-Ce adsorbent in fluoride adsorption, Ind. Eng. Chem. Res, 48 (9), 4530–4534.

[15] dos Santos, D.S.S., Teixeira, A.P., Barbosa, J.T.P., Ferreira, S.L.C., Korn, M.G.A., and Teixeira, L.S.G., 2007, Use of cetyltrimethylammonium bromide as surfactant for the determination of copper and chromium in gasoline emulsions by electrothermal atomic absorption spectrometry, Spectrochim. Acta, Part B, 62 (9), 1072–1077.

[16] Karthik, R., and Meenakshi, S., 2014, Removal of hexavalent chromium ions using polyaniline/silica gel composite, J. Water Process Eng., 1, 37–45.

[17] Bi, Z., Liao, W., and Qi, L., 2004, Wettability alteration by CTAB adsorption at surfaces of SiO2 film or silica gel powder and mimic oil recovery, Appl. Surf. Sci., 221 (1-4), 25–31.

[18] Bryleva, E.Y., Vodolazkaya, N.A., Mchedlov-Petrossyan, N.O., Samokhina, L.V., Matveevskaya, N.A., and Tolmachev, A.V., 2007, Interfacial properties of cetyltrimethylammonium-coated SiO2 nanoparticles in aqueous media as studied by using different indicator dyes, J. Colloid Interface Sci., 316 (2), 712–722.

[19] Koner, S., Pal, A., and Adak, A., 2010, Cationic surfactant adsorption on silica gel and its application for wastewater treatment, Desalin. Water Treat., 22 (1-3), 1–8.

[20] Yu, Q., Hui, J., Wang, P., and Wang, X., 2012, Anion-exchange-driven disassembly of a SiO2/CTAB composite mesophase: The formation of hollow mesoporous silica spheres, Inorg. Chem., 51 (17), 9539–9543.

[21] Venditti, F., Ceglie, A., Palazzo, G., Colafemmina, G., and Lopez, F., 2007, Removal of chromate from water by a new CTAB-silica gelatin composite, J. Colloid Interface Sci., 310 (2), 353–361.

[22] Fouconnier, B., Román-Guerrero, A., and Vernon-Carter, E.J., 2012, Effect of [CTAB]-[SiO2] ratio on the formation and stability of hexadecane/water emulsions in the presence of NaCl, Colloids Surf., A, 400, 10–17.

[23] Zhang, Y., Liu, C., Luo, L., Shi, Y., Chen, Y., Wang, S., Bian, L., and Jiang, F., 2017, One-step hydrothermal synthesis of CTAB-modified SiO2 for removal of bisphenol A, Water Sci. Technol., 76 (3-4), 928–938.

[24] Bowman, R.S., 2003, Applications of surfactant-modified zeolites to environmental remediation, Microporous Mesoporous Mater., 61 (1-3), 43–56.

[25] Jović-Jovičić, N., Milutinović-Nikolić, A., Banković, P., Dojčinović, B., Nedić, B., Gržetić, I., and Jovanović, D., 2010, Synthesis, characterization and adsorptive properties of organobentonites, Acta Phys. Pol. A, 117 (5), 849–854.

[26] Ali, I.O., Hassan, A.M., Shaaban, S.M., and Soliman, K.S., 2011, Synthesis and characterization of ZSM-5 zeolite from rice husk ash and their adsorption of Pb2+ onto unmodified and surfactant-modified zeolite, Sep. Purif. Technol., 83, 38–44.


Article Metrics

Abstract views : 3314 | views : 3762

Copyright (c) 2018 Indonesian Journal of Chemistry

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.


Indonesian Journal of Chemistry (ISSN 1411-9420 /e-ISSN 2460-1578) - Chemistry Department, Universitas Gadjah Mada, Indonesia.

Analytics View The Statistics of Indones. J. Chem.