Bismuth Oxide Prepared by Sol-Gel Method: Variation of Physicochemical Characteristics and Photocatalytic Activity Due to Difference in Calcination Temperature

https://doi.org/10.22146/ijc.53144

Yayuk Astuti(1*), Brigita Maria Listyani(2), Linda Suyati(3), Adi Darmawan(4)

(1) Department of Chemistry, Faculty of Science and Mathematics, Diponegoro University, Jl. Prof. Soedharto SH, Tembalang, Semarang 50275, Indonesia
(2) Department of Chemistry, Faculty of Science and Mathematics, Diponegoro University, Jl. Prof. Soedharto SH, Tembalang, Semarang 50275, Indonesia
(3) Department of Chemistry, Faculty of Science and Mathematics, Diponegoro University, Jl. Prof. Soedharto SH, Tembalang, Semarang 50275, Indonesia
(4) Department of Chemistry, Faculty of Science and Mathematics, Diponegoro University, Jl. Prof. Soedharto SH, Tembalang, Semarang 50275, Indonesia
(*) Corresponding Author

Abstract


Research on synthesis of bismuth oxide (Bi2O3) using sol-gel method with varying calcination temperatures at 500, 600, and 700 °C has been done. This study aims to determine the effect of calcination temperature on the characteristics of the obtained products which encompasses crystal structure, surface morphology, band-gap energy, and photocatalytic activity for the decolorization of methyl orange dyes through its kinetic study. Bismuth oxide prepared by sol-gel method was undertaken by dissolving Bi(NO3)3·5H2O and citric acid in HNO3. The mixture was stirred then heated at 100 °C. The gel formed was dried in the oven and then calcined at 500, 600, and 700 °C for 5 h. The obtained products were a pale yellow powder, indicating the formation of bismuth oxide. This is confirmed by the existence of Bi–O and Bi–O–Bi functional groups through FTIR analysis. All three products possess the same mixed crystal structures of α-Bi2O3 (monoclinic) and γ-Bi2O3 (body center cubic), but their morphologies and band gap values are different. The higher the calcination temperature, the larger the particle size and the smaller the band gap value. The accumulative differences in characteristics appoint SG700 to have the highest photocatalytic activity compared to SG600 and SG500 as indicated by its percent degradation value and decolorization rate constant.


Keywords


bismuth oxide; sol-gel; calcination temperature; photocatalytic activity; photocatalyst

Full Text:

Full Text PDF


References

[1] Mallahi, M., Shokuhfar, A., Vaezi, M.R., Esmaeilirad, A., and Mazinani, V., 2014, Synthesis and characterization of bismuth oxide nanoparticles via sol-gel method, Am. J. Eng. Res., 3 (4), 162–165.

[2] Sammes, N.M., Tompsett, G.A., Näfe, H., and Aldinger, F., 1999, Bismuth based oxide electrolytes–Structure and ionic conductivity, J. Eur. Ceram. Soc., 19 (10), 1801–1826.

[3] Weidong, H., Wei, Q., Xiaohong, W., Xianbo, D., Long, C., and Zhaohua, J., 2007, The photocatalytic properties of bismuth oxide films prepared through the sol–gel method, Thin Solid Films, 515 (13), 5362–5365.

[4] Zhang, L., Ghimire, P., Phuriragpitikhon, J., Jiang, B., Gonçalves, A.A.S, and Jaroniec, M., 2018, Facile formation of metallic bismuth/bismuth oxide heterojunction on porous carbon with enhanced photocatalytic activity, J. Colloid Interface Sci., 513, 82–91.

[5] Reverberi, A.P., Varbanov, P.S., Vocciante, M., and Fabiano, B., 2018, Bismuth oxide-related photocatalysts in green nanotechnology: A critical analysis, Front. Chem. Sci. Eng., 12 (4), 878–892.

[6] Jiang, H.Y., Li, P., Liu, G., Ye, J., and Lin, J., 2015, Synthesis and photocatalytic properties of metastable β-Bi2O3 stabilized by surface-coordination effects, J. Mater. Chem. A, 3 (9), 5119–5125.

[7] Yilmaz, S., Turkoglu, O., Ari, M., and Belenli, I., 2011, Electrical conductivity of the ionic conductor tetragonal (Bi2O3)1-x(Eu2O3)x, Cerâmica, 57 (342), 185–192.

[8] Astuti, Y., Andianingrum, R., Arnelli, A., Haris, A., and Darmawan, A., 2020, The role of H2C2O4 and Na2CO3 as precipitating agents on the physichochemical properties and photocatalytic activity of bismuth oxide, Open Chem., 18 (1), 129–137.

[9] Hernandez-Delgadillo, R., Velasco-Arias, D., Martinez-Sanmiguel, J.J., Diaz, D., Zumeta-Dube, I., Arevalo-Niño, K., and Cabral-Romero, C., 2013, Bismuth oxide aqueous colloidal nanoparticles inhibit Candida albicans growth and biofilm formation, Int. J. Nanomed., 8, 1645–1652.

[10] La, J., Huang, Y., Luo, G., Lai, J., Liu, C., and Chu, G., 2013, Synthesis of bismuth oxide nanoparticles by solution combustion method, Part. Sci. Technol., 31 (3), 287–290.

[11] Astuti, Y., Fauziyah, A., Widiyandari, H., and Widodo, D.S., 2019, Studying impact of citric acid-bismuth nitrate pentahydrate ratio on photocatalytic activity of bismuth oxide prepared by solution combustion method, Rasayan J. Chem., 12 (4), 2210–2217.

[12] Astuti, Y., Elesta, P.P., Widodo, D.S., Widiyandari, H., and Balgis, R., 2020, Hydrazine and urea fueled-solution combustion method for Bi2O3 synthesis: Characterization of physicochemical properties and photocatalytic activity, Bull. Chem. React. Eng. Catal., 15 (1), 104111.

[13] Wu, C., Shen, L., Huang, Q., and Zhang, Y.C., 2011, Hydrothermal synthesis and characterization of Bi2O3 nanowires, Mater. Lett., 65 (7), 1134–1136.

[14] Amiri, A., 2016, Solid-phase microextraction-based sol–gel technique, TrAC, Trends Anal. Chem., 75, 57–74.

[15] Pinjari, D.V., Prasad, K., Gogate, P.R., Mhaske, S.T., and Pandit, A.B., 2015, Synthesis of titanium dioxide by ultrasound assisted sol–gel technique: effect of calcination and sonication time, Ultrason. Sonochem., 23,185–191.

[16] Danks, A.E., Hall, S.R., and Schnepp, Z., 2016, The evolution of ‘sol–gel’ chemistry as a technique for materials synthesis, Mater. Horiz., 3 (2), 91–112.

[17] Messel, H., 2014, Abridged Science for High School Students: The Nuclear Research Foundation School Certificate Integrated, Vol. II, Elsevier, London, UK.

[18] Miedema, A.R., Boom, R., and De Boer, F.R., 1975, On the heat of formation of solid alloys, J. Less Common. Met., 41 (2), 283–298.

[19] Xiaohong, W., Wei, Q., and Weidong, H., 2007, Thin bismuth oxide films prepared through the sol–gel method as photocatalyst, J. Mol. Catal. A: Chem., 261 (2), 167–171.

[20] Jiang, Z., and Wang, Y., 2015, Preparation of porous bismuth oxide by sol-gel method using citric acid, Material Science and Environmental Engineering: Proceedings of the 3rd Annual 2015 International Conference on Material Science and Environmental Engineering (ICMSEE2015), Wuhan, Hubei, China, 5-6 June 2015.

[21] Dimesso, L., 2016, “Pechini processes: An alternate approach of the sol–gel method, preparation, properties, and applications” in Handbook of Sol-Gel Science and Technology, Springer, Cham, Switzerland, 1–22.

[22] Eastaugh, N., Walsh, V., Chaplin, T., and Siddall, R., 2008, Pigment Compendium: A Dictionary and Optical Microscopy of Historical Pigments, Routledge, London, UK.

[23] Selvapandiyan, M., and Sathiyaraj, K., 2019, Synthesis, preparation, structural, optical, morphological and elemental analysis of bismuth oxides nanoparticles, Silicon, 1–7.

[24] Bartonickova, E., Cihlar, J., and Castkova, K., 2007, Microwave-assisted synthesis of bismuth oxide, Process. Appl. Ceram., 1 (1-2), 29–33.

[25] Bandyopadhyay, S., and Dutta, A., 2017, Thermal, optical and dielectric properties of phase stabilized δ–Dy-Bi2O3 ionic conductors, J. Phys. Chem. Solids, 102, 12–20.

[26] Zhong, S., Zou, S., Peng, X., Ma, J., and Zhang, F., 2015, Effects of calcination temperature on preparation and properties of europium-doped bismuth oxide as visible light catalyst, J. Sol-Gel Sci. Technol., 74 (1), 220–226.

[27] Zhang, G., Hu, L., Wang, P., and Yuan, Y., 2017, The effect of calcination temperature on the performance of Co3O4-Bi2O3 as a heterogeneous catalyst of peroxymonosulfate, IOP Conf. Ser.: Earth Environ. Sci., 94, 012029.

[28] Cheng, H., Huang, B., Lu, J., Wang, Z., Xu, B., Qin, X., Zhang, X., and Dai, Y., 2010, Synergistic effect of crystal and electronic structures on the visible-light-driven photocatalytic performances of Bi2O3 polymorphs, Phys. Chem. Chem. Phys., 12 (47), 15468–15475.

[29] Hou, J., Yang, C., Wang, Z., Zhou, W., Jiao, S., and Zhu, H., 2013, In situ synthesis of α–β phase heterojunction on Bi2O3 nanowires with exceptional visible-light photocatalytic performance, Appl. Catal., B, 142-143, 504–511.

[30] Liu, X., Deng, H., Yao, W., Jiang, Q., and Shen, J., 2015, Preparation and photocatalytic activity of Y-doped Bi2O3, J. Alloys Compd., 651, 135–142.

[31] Wang, Q., Hui, J., Yang, L., Huang, H., Cai, Y., Yin, S., and Ding, Y., 2014, Enhanced photocatalytic performance of Bi2O3/H-ZSM-5 composite for rhodamine B degradation under UV light irradiation, Appl. Surf. Sci., 289, 224–229.

[32] Astuti, Y., Amri, D., Widodo, D.S., Widiyandari, H., Balgis, R., and Ogi, T., 2020, Effect of fuels on the physicochemical properties and photocatalytic activity of bismuth oxide, synthesized using solution combustion method, Int. J. Technol., 11 (1), 26–36.



DOI: https://doi.org/10.22146/ijc.53144

Article Metrics

Abstract views : 5073 | views : 4329


Copyright (c) 2020 Indonesian Journal of Chemistry

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

 


Indonesian Journal of Chemistry (ISSN 1411-9420 /e-ISSN 2460-1578) - Chemistry Department, Universitas Gadjah Mada, Indonesia.

Web
Analytics View The Statistics of Indones. J. Chem.