Speed and Lane Change Characteristics of Motorcycles at Priority Junction
DOI:
https://doi.org/10.22146/jcef.26617Keywords:
Motorcycle; speed; lane-change; priority junction; traffic safetyAbstract
Motorcycles are Indonesia’s predominant mode of transportation and contribute to a substantial share of road traffic accidents. The research aims to identify key behavioural factors contributing to motorcycle-related conflict risks at intersections and to propose evidence-based safety interventions. This study analyzed speed characteristics with varying degrees of disruption that motorists would experience at the intersection. These disruptions were categorized into high, low, no disruption, and left-turn movements. High disruption was defined as vehicles stopping in the middle of the intersection as motorcyclists approached, while low disruption was defined as vehicles preparing to enter the intersection from minor roads. In addition to speed characteristics, this study also observed lane-changing behavior when disruptions occurred at the intersection. To obtain detailed data, drone-based cameras were used for observations, and the results were validated against radar speed measurements. The results show that 67.94% of riders exceed the 60 km/h speed limit during the morning period, while 33.27% exceed it in the afternoon, indicating clear temporal differences in operating speeds. Approximately 85 per cent of lane-changing manoeuvres occur within 20 metres of the conflict point, reflecting short decision distances that increase collision risk. Riders also exhibit assertive gap-acceptance behaviour, often requiring main-road vehicles to adjust their speed. Statistical validation confirms that there is no significant difference between drone-derived and radar-based speed measurements, demonstrating the reliability of the drone-based methodology. Based on these findings, the study recommends targeted speed management measures, including automated enforcement and the use of traffic-calming devices; improved lane discipline through more precise road markings and selective physical separation; and junction design enhancements, such as motorcycle waiting areas and advanced stop lines. These measures can improve motorcycle safety at priority junctions and support more efficient and predictable urban traffic operations.
References
Abdul Manan, M. M., Várhelyi, A., Çelik, A. K. and Hashim, H. H. (2018), ‘Road characteristics and environment factors associated with motorcycle fatal crashes in malaysia’, IATSS Research 42(4), 207–220. URL: https://doi.org/10.1016/J.IATSSR.2017.11.001
Amegah, M. L., Adanu, E. K., Kolawole Ojo, T., Bukari, S. and Asare-Akuffo, F. (2023), ‘Exploration of motorcyclists’ red-light running and helmet use at signalized intersections in ghana’, Traffic Injury Prevention 24(1), 94–97. URL: https://doi.org/10.1080/15389588.2022.2127321
Anggraini, R., Isya, M., Fadhly, N. and Mutiawati, C. (2024), Risk factors associated with stress related riding behavior among indonesian motorcyclists, in ‘IOPConference Series: Earth and Environmental Science’, Vol. 12.
Aziz, F., Mahmudah, N., Augeri, M. and Comi, A. (2025), ‘Advancing road safety in urban area: The impact of roundabouts on intersection design’, Journal of the Civil Engineering Forum 11(2), 191–202. URL: https://doi.org/10.22146/jcef.15904
Cameron, M. H. and Elvik, R. (2010), ‘Nilsson’s power model connecting speed and road trauma: Applicability by road type and alternative models for urban roads’, Accident Analysis and Prevention 42(6), 1908–1915. URL: https://doi.org/10.1016/j.aap.2010.05.012
Elvik, R. (2005), ‘Speed and road safety: Synthesis of evidence from evaluation studies’, Transportation Research Record 1908, 59–69. URL: https://doi.org/10.3141/1908-08
Firmansyah, D., Irawan, M. Z., Amrozi, M. R. F. and Muthohar, I. (2025), ‘Uncovering motivations for innovation in urban commuting: A segmentation of jakarta’s motorcyclists’, Journal of Open Innovation: Technology, Market, and Complexity 11(3). URL: https://doi.org/10.1016/j.joitmc.2025.100614
Gulati, S. (2025), Choosing the right sample size, in ‘Translational Gastroenterology’, Elsevier, pp. 315–316. URL: https://doi.org/10.1016/B978-0-12-821426-8.00007-8
Ibrahim, N. A., Subramaniam, A., Jabar, S. N. and Rahman, S. A. (2024), ‘Analyzing energy consumption and emissions: A comparative study of kuala terengganu driving cycles during varied peak hours with traffic congestion insights’, International Journal of Transport Development and Integration 8(2), 261–270. URL: https://doi.org/10.18280/ijtdi.080205
International Transport Forum (2018), ‘Speed and crash risk’. Accessed: 16 November 2025. URL: https://www.itf-oecd.org/speed-crash-risk
Intini, P., Berloco, N., Cavalluzzi, G., Lord, D., Ranieri, V. and Colonna, P. (2021), ‘The variability of urban safety performance functions for different road elements: an italian case study’, European Transport Research Review 13(1). URL: https://doi.org/10.1186/s12544-021-00490-6
Irawan, M. Z., Rizki, M., Chalermpong, S. and Kato, H. (2022), ‘Mapping the motorcycle-based ride-hailing users in yogyakarta: An analysis of socio-economic factors and preferences’, Asian Transport Studies 8. URL: https://doi.org/10.1016/j.eastsj.2022.100073
Kilani, O., Gouda, M., Weiß, J. and El-Basyouny, K. (2021), ‘Safety assessment of urban intersection sight distance using mobile lidar data’, Sustainability 13(16). URL: https://doi.org/10.3390/su13169259
Kurniati, T., Afyendo, E. and Putri, E. E. (2020), Study of potential implementations for motorcycle lanes in padang city, in ‘IOP Conference Series: Materials Science and Engineering’. URL: https://doi.org/10.1088/1757-899X/933/1/012033
Kurniati, T., Purnawan, Yosritzal and Putri, E. E. (2020), Evaluation of the implementation of the motorcycle lane based on the riding experience, in ‘IOP Conference Series: Materials Science and Engineering’. URL: https://doi.org/10.1088/1757-899X/771/1/012060
Losa, M., Frendo, F., Cofrancesco, A. and Bartolozzi, R. (2013), ‘A procedure for validating fixed-base driving simulators’, Transport 28(4), 420–430. URL: https://doi.org/10.3846/16484142.2013.867281
Lubbe, N., Wu, Y. and Jeppsson, H. (2022), ‘Safe speeds: fatality and injury risks of pedestrians, cyclists, motorcyclists, and car drivers impacting the front of another passenger car as a function of closing speed and age’, Traffic Safety Research 2. URL: https://doi.org/10.55329/vfma7555
Lumba, P., Ariyanto, A. and Fathoni, A. (2024), ‘Strategies for enhancing traffic safety among adolescent and adult motorcycle riders in indonesia’, Jordan Journal of Civil Engineering 18(2), 293–307. URL: https://doi.org/10.14525/JJCE.v18i2.11
Mohan, D. (2016), Speed and its effects on road traffic crashes, in ‘Transport Planning and Traffic Safety: Making Cities, Roads, and Vehicles Safer’. URL: https://doi.org/10.1201/b19737-10
Mokhtar, N. H., Hamzah, L., Mamat, H. C., Nasir, M. Z. M. and Mamat, M. F. (2023), Decreasing the rate of motorcycle accidents in malaysia: Analytical hierarchy process approach, in ‘AIP Conference Proceedings’. URL: https://doi.org/10.1063/5.0114323
Paul, M. and Ghosh, I. (2021), ‘Development of conflict severity index for safety evaluation of severe crash types at unsignalized intersections under mixed traffic’, Safety Science 144. URL: https://doi.org/10.1016/j.ssci.2021.105432
Pujiantoro, W. and Manullang, O. R. (2025), ‘Safety paradox: Risk perceptions, safety attitudes, and riding behaviors of young food-delivery platform workers in indonesia’, European Transport - Trasporti Europei (101). URL: https://www.scopus.com/inward/record.uri?eid=2-s2.0105005005277partnerID=40md5=24022ff2e38c803dc-7ae1da4f0d0ee88
Rusli, R., Oviedo-Trespalacios, O. and Abd Salam, S. A. (2020), ‘Risky riding behaviours among motorcyclists in malaysia: A roadside survey’, Transportation Research Part F: Traffic Psychology and Behaviour 74, 446–457. URL: https://doi.org/10.1016/j.trf.2020.08.031
Shafie, S. A. M., Leong, L. V., Hao, S. T. and Yuen, C. W. (2022), ‘Assessing the risky riding behavior and the effect of entrance behavior of right-turning motorcyclists on critical gap at t-junctions’, Transportation Engineering 10. URL: https://doi.org/10.1016/j.treng.2022.100154
Tanishita, M. and van Wee, B. (2017), ‘Impact of vehicle speeds and changes in mean speeds on per vehiclekilometer traffic accident rates in japan’, IATSS Research 41(3), 107–112. URL: https://doi.org/10.1016/j.iatssr.2016.09.003
Torrão, G. (2022), ‘Speed related variables for crash injury risk analysis: what has been used?’, International Journal of Crashworthiness 27(5), 1560–1567. URL: https://doi.org/10.1080/13588265.2021.1959152
Tseng, C.-M. (2013), ‘Speeding violations related to a driver’s social-economic demographics and the most frequent driving purpose in taiwan’s male population’, Safety Science 57, 236–242. URL: https://doi.org/10.1016/j.ssci.2013.02.005
Wang, T., Wang, T., Liao, P., Cao, F., Tang, T.-Q. and Ning, D. (2025), ‘Diverging and merging of household and individual commuter flows in morning commute problem’, Transport Policy 169, 101–115. URL: https://doi.org/10.1016/j.tranpol.2025.04.013
Downloads
Published
How to Cite
Issue
Section
License
Copyright is granted to authors for the purpose of providing protection for articles written to describe experiments and their results. JCEF will protect and defend the work and reputation of the author and are also willing to address any allegations of violation, plagiarism, fraud, etc. against articles written and published by JCEF. JCEF is published under the terms of the Creative Commons Attribution-ShareAlike 4.0 International License (CC BY-SA 4.0). The author holds the copyright and assigns the journal rights to the first publication (online and print) of the work simultaneously.
