STUDY ON THE ADSORPTION PROPERTIES OF NOVEL CALIX[6]ARENE POLYMERS FOR HEAVY METAL CATIONS

https://doi.org/10.22146/ijc.21368

Susy Yunita Prabawati(1*), Jumina Jumina(2), Sri Juari Santosa(3), Mustofa Mustofa(4), Keisuke Ohto(5)

(1) Department of Chemistry, Faculty of Science and Technology, UIN Sunan Kalijaga of Yogyakarta, Indonesia
(2) Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Sekip Utara, Yogyakarta 55281
(3) Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Sekip Utara, Yogyakarta 55281
(4) Department of Pharmacology and Toxicology, Faculty of Medicine, Universitas Gadjah Mada, Yogyakarta 55281
(5) Department of Applied Chemistry, Faculty of Science and Engineering, Saga University, 1-Honjo, Saga, 840-8502
(*) Corresponding Author

Abstract


A research has been conducted to investigate the capability of a series of novel calix[6]arenes-based polymers: poly-monoallyloxycalix[6]arene (2a), poly-monoallyloxypenta-estercalix[6]arene (2b) and poly-monoallyloxypenta-acidcalix[6]arene (2c) for trapping of heavy metal cations such as Cd(II), Cu(II) and Cr(III). The existence of active hydroxy group (-OH) and with a tunnel-like structure of the polymers, caused the polymers can be used as adsorbents for heavy metals. The adsorption process was carried out in batch method in the variation of acidity (pH), contact time and initial concentration of metal ions. The results showed that the amount of adsorbed metal increased with the increasing of the pH of metal solution. For these three polymers, the amount of metal ions Cd(II), Cu(II) and Cr(III) adsorbed was optimum at pH 7, 6 and 5 respectively. The optimum contact time for Cd(II) and Cu(II) was 120 min, while that for Cr(III) was 60 min. Study of the adsorption kinetics showed that the adsorption of Cd(II), Cu(II) and Cr(III) using polymer 2a followed kinetics model of Ho. For adsorbent 2b and 2c, the adsorption kinetics of Cd(II) and Cr(III) also followed kinetics model of Ho while for the Cu(II) followed Lagergren kinetic models. Isothermal studies showed that the adsorption of metal ions on all adsorbents tend to follow the Langmuir isotherm. The adsorption energies of the three adsorbents were higher than 23 kJ/mole and polymer 2c has the largest adsorption capacity for Cr(III).

Keywords


Calix[6]arene-based polymers; Cd(II); Cu(II); Cr(III); adsorption kinetic; isotherm adsorption

Full Text:

Full Text Pdf


References

[1] Benhammou, A., Yaacoubi, A., Nibou, L., and Tanouti, B., 2005, J. Colloid Interface Sci., 282, 2, 320–326.

[2] Flora, S.J.S., Saxena, G., Gautama, P., Kaur, P., and Gill, K.D., 2007, Chem. Biol. Interact., 170, 3, 209–220.

[3] Massó, E.L., Corredor, L., and Antonio, M.T.J., 2007, Trace Elem. Med. Biol., 21, 3, 210–216.

[4] Tabakci, M., and Yilmaz, M., 2008, J. Hazard. Mater., 151, 2-3, 331–338.

[5] Solangi, I.B., Memon, S., and Bhanger, M.I., 2009, Anal. Chim. Acta, 638, 2, 146–153.

[6] Ahmad, F., 2009, Makara Sains, 13, 2, 117–124.

[7] Liu, C.C., Wang, M.K., and Li, Y.S., 2005, Ind. Eng. Chem. Res., 44, 5, 1438–1445.

[8] Mellah, A., Chegrouche, S., and Barkat, M., 2006, J. Colloid Interface Sci., 296, 2, 434–441.

[9] Gutsche, C.D., 1998, Calixarenes Revisited, The Royal Society of Chemistry, Cambridge.

[10] Becker, A., Tobias, H., Porat, Z., and Mandler D., 2008, J. Electroanal. Chem., 621, 214–221.

[11] Lang, J., Dybal, J., Makrlik, E., Vanura, P., Vasickova, S., and Malon, P., 2007, J. Mol. Struct., 846, 1-3, 157–160.

[12] Kunsagi-Mate, S., Szabo, K., Lemli, B., Bitter, I., Nagy, G., and Kollar, L., 2005, Thermochim. Acta, 425, 1-2, 121–126.

[13] Chen, M., Shang, T., Fang, W., and Diao, G., 2011, J. Hazard. Mater., 185, 2-3, 914–921.

[14] Brindle, R., Albert, K., Harris, S.J., Tröltzsch, C., Horne, E., and Glennon, J.D., 1996, J. Chromatogr. A, 731, 1-2, 41–46.

[15] Yang, F.F., Guo, H.Y., Lin, J.R., and Yuan Yin Chen, Y.Y., 2003, Chin. Chem. Lett., 14, 5, 453–455.

[16] Prabawati, S.Y., Jumina, Santosa, S.J., and Mustofa, 2011, Indo. J. Chem., 11, 1, 37–42.

[17] Handayani, D.S., Jumina, Santosa, S.J., and Mustofa, 2011, Indo. J. Chem, 11, 2, 191–195.

[18] Prabawati, S.Y., Jumina, Santosa, S.J., and Mustofa, 2011, Synthesis of a Series of Calix[6]-arene Polymers from p-ter-butylphenol, Proceeding of the International Conference on Bioscience and Biotechnology, State Islamic University of Yogyakarta, 11-12 October 2011.

[19] Santosa, S.J., Siswanta, D., Kurniawan, A., and Rahmanto, W.H., 2007, Surf. Sci., 601, 5155–5161.

[20] Santosa, S.J., Narsito, and Lesbani, A., 2003, J. Ion Exch., 14, 89–91.

[21] Ho, Y.S., 2004, Scientometrics, 59, 1, 171–177.

[22] Utomo, S.B., Jumina, and Wahyuningsih, T.D., 2009, Indo. J. Chem., 9, 3, 437–444.

[23] Adamson, A.W., 1990, Physical Chemistry of Surface, 5th ed., John Wiley & Sons, New York, 381–382.

[24] Pramuwati, E., 2005, Study on The Adsorption of Pb(II), Cu(II) and Cr(III) using p-tert-buthylcalix[4]arene, Under Graduate Thesis, FMIPA-UGM, Yogyakarta.

[25] Anitasari, F., 2009, Study on The Adsorption of Pb(II) and Cr(III) using Poly-5-allyl-25,26,27,28-tetrahydroxycalix[4]arene as The Adsorbent, Under Graduate Thesis, FMIPA-UGM, Yogyakarta.

[26] Gupta, V.K., and Ali, I., 2000, Purif. Technol., 18, 2, 131–140.

[27] Villaescusa, I., Fiol, N., Martinez, M., Miralles, N., Poch, J., and Serarols, J., 2004, Water Res., 38, 4, 992–1002.



DOI: https://doi.org/10.22146/ijc.21368

Article Metrics

Abstract views : 2858 | views : 1847


Copyright (c) 2012 Indonesian Journal of Chemistry

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

 

Indonesian Journal of Chemistry (ISSN 1411-9420 /e-ISSN 2460-1578) - Chemistry Department, Universitas Gadjah Mada, Indonesia.

Web Analytics View The Statistics of Indones. J. Chem.