In-Situ Ionic Imprinted Membrane (IIM) Synthesis Based on Acetic Polyeugenoxy Acetyl Tiophen Methanolate for Gold(III) Metal Ion Transports

Muhammad Cholid Djunaidi; Pardoyo Pardoyo; Didik Setiyo Widodo; Retno Ariadi Lusiana; Anggun Yuliani

doi:10.22146/ijc.49941

In-Situ Ionic Imprinted Membrane (IIM) Synthesis Based on Acetic Polyeugenoxy Acetyl Tiophen Methanolate for Gold(III) Metal Ion Transports

https://doi.org/10.22146/ijc.49941

Muhammad Cholid Djunaidi^(1*), Pardoyo Pardoyo⁽²⁾, Didik Setiyo Widodo⁽³⁾, Retno Ariadi Lusiana⁽⁴⁾, Anggun Yuliani⁽⁵⁾

(1) Department of Chemistry, Faculty of Science and Mathematics, Diponegoro University, Jl. Prof. Soedharto SH, Tembalang, Semarang 50275, Indonesia
(2) Department of Chemistry, Faculty of Science and Mathematics, Diponegoro University, Jl. Prof. Soedharto SH, Tembalang, Semarang 50275, Indonesia
(3) Department of Chemistry, Faculty of Science and Mathematics, Diponegoro University, Jl. Prof. Soedharto SH, Tembalang, Semarang 50275, Indonesia
(4) Department of Chemistry, Faculty of Science and Mathematics, Diponegoro University, Jl. Prof. Soedharto SH, Tembalang, Semarang 50275, Indonesia
(5) Department of Chemistry, Faculty of Science and Mathematics, Diponegoro University, Jl. Prof. Soedharto SH, Tembalang, Semarang 50275, Indonesia
(*) Corresponding Author

Abstract

In this research, Polyeugenoxy Acetyl Tiophen Methanolate (PEATM)-Au ionic imprinted membrane (IIM) was synthesized. IIM is a PEATM based membrane that has Au(III) ion molds. The PEATM synthesis was analyzed using FTIR spectroscopy, and its relative molecular weight was determined by the viscometry method. To find out the presence of Au(III) templates on IIM, FTIR spectroscopy and SEM-EDX were used. The results of FTIR spectroscopy & SEM-EDX analysis prove the existence of Au(III) metal ion templates at IIM. Through FTIR spectra, it could be seen that the absorption area of the -OH group was widening. In the IIM, the CS group wave number (702.9 cm^–1) also shifted to a larger wavenumber (848.68 cm^–1), this is likely due to the presence of PEGDE as a crosslinker agent and PVA as a plasticizer on the membrane that interacts with PEATM-Au, which influences the shift of vibrational wavenumber of CS bonds. It was also found that the most effective pH of the feed phase for the transport was at pH 3, and the most optimum transport time was 24 h for IIM and 48 h for NIM. The transport of Au in binary mixture of Au/Cd, Au/Fe, and Au/Pb also proves that the presence of Au(III) ions in IIM makes IIM more selective to Au(III) metal ions than NIM when used for the transport process as it transports Au more than the other metals. These results were as expected by using the HSAB theory as its groundwork.

Keywords

ionic imprinted membrane; gold metal ion; transport; selectivity; binary metal ions

Full Text:

Full Text PDF

References

[1] Ogata, T., and Nakano, Y., 2005, Mechanisms of gold recovery from aqueous solutions using a novel tannin adsorbent gel synthesized from natural condensed tannin, Water Res., 39 (18), 4281–4286.

[2] Lestari, P., 2017, Adsorpsi ion emas menggunakan asam humat tanah gambut di bawah radiasi sinar UV, JST, 6 (1), 168–177.

[3] Torre, M., Bachiller, D., Rendueles, M., Menéndez, C.O., and Díaz, M., 2006, Cyanide recovery from gold extraction process waste effluents by ion exchange I. Equilibrium and kinetics, Solvent Extr. Ion Exch., 24 (1), 99–117.

[4] Rochat, D., Hagelüken, C., Keller, M., and Widmer, R., 2007, Optimal recycling for printed wiring boards (PWBs) in India, R’07 World Congress - Recovery of Materials and Energy for Resource Efficiency, 3-5 September 2007, Davos, Switzerland.

[5] Nghiem, L.D., Mornane, P., Potter, I.D., Perera, J.M., Cattrall, R.W., and Kolev, S.D., 2006, Extraction and transport of metal ions and small organic compounds using polymer inclusion membranes (PIMs), J. Membr. Sci., 281 (1-2), 7–41.

[6] Yoshikawa, M., 2001, Molecularly imprinted polymeric membranes, Bioseparation, 10 (6), 277–286.

[7] Vatanpour, V., Madaeni, S.S., Zinadini, S., and Rajabi, H.R., 2011, Development of ion imprinted technique for designing nickel ion selective membrane, J. Membr. Sci., 373 (1-2), 36–42.

[8] Buhani, Narsito, Nuryono, and Kunarti, E.S., 2013, Chemical stability of Cd(II) and Cu(II) ionic imprinted amino-silica hybrid materials in solution media, Eksakta, 13 (1-2), 1–10.

[9] Djunaidi, M.C., Khabibi, and Ulumudin, I., 2017, Separation of Cu2⁺, Cd²⁺ and Cr³⁺ in a mixture solution using a novel carrier poly(methyl thiazoleethyl eugenoxy acetate) with BLM (bulk liquid membrane), IOP Conf. Ser.: Mater. Sci. Eng., 172, 012032.

[10] Djunaidi, M.C., Wibawa, P.J., and Murti, R.H., 2018, Synthesis of a carrier compound thiazoethyl methyl eugenoxyacetate from eugenol and its use in the bulk liquid membrane technique, Indones. J. Chem., 18 (1), 121–126.

[11] Qu, R., Sun, C., Wang, M., Ji, C., Xu, Q., Zhang, Y., Wang, C., Chen, H., and Yin, P., 2009, Adsorption of Au(III) from aqueous solution using cotton fiber/chitosan composite adsorbents, Hydrometallurgy, 100 (1-2), 65–71.

[12] Djunaidi, M.C., Lusiana, R.A., Pardoyo, Widodo, D.S., and Utami, T.W., 2019, Synthesis of polieugenoxy acetyl thiophene methanolate as a new selective carrier, IOP Conf. Ser.: Mater. Sci. Eng., 509, 012068.

[13] Putrie, Z.M., 2013, Sintesis membran hibrida kitosan silika grafting silfonat sebagai proton exchange membran, Master Thesis, Department of Chemical Engineering, Institut Teknologi Sepuluh Nopember, Surabaya, Indonesia.

[14] Bolto, B., Tran, T., Hoang, M., and Xie, Z., 2009, Cross-linked poly(vinyl alcohol) membranes, Prog. Polym. Sci., 34 (9), 969–981.

[15] Merle, G., Hosseiny, S.S., Wessling, M., and Nijmeijer, K., 2012, New cross-linked PVA based polymer electrolyte membranes for alkaline fuel cells, J. Membr. Sci., 409-410, 191–199.

[16] Djunaidi, M.C., Jumina, J., Siswanta, D., and Ulbricht, M., 2015, Synthesis of Fe ionic-imprinted polyeugenol using polyethylene glycol diglycidylether as cross-linking agent for sorption of Fe(III), Indones. J. Chem., 15 (3), 305–314.

[17] González, M.A.G., Edlund, U., Vidaurre, A., and Ribelles, J.L.G., 2017, Synthesis of highly swellable hydrogels of water-soluble carboxymethyl chitosan and poly(ethylene glycol), Polym. Int., 66 (11), 1624–1632.

[18] Atkins, P.W., and de Paula, J., 2010, Atkins’ Physical Chemistry, 9^th Ed., Oxford University Press, Oxford, New York.

[19] Marcus, Y., 1991, Thermodynamics of solvation of ions. Part 5.–Gibbs free energy of hydration at 298.15 K, J. Chem. Soc., Faraday Trans., 87 (18), 2995–2999.

[20] Groenewald, T., 1976, The dissolution of gold in acidic solutions of thiourea, Hydrometallurgy, 1 (3), 277–290.

[21] Nicol, M.J., Fleming, C.A., and Paul, R.L., 1992, “The chemistry of the extraction of gold” in The Extractive Metallurgy of Gold, Eds. Stanley, G.G., South African Institute of Mining and Metallurgy, Johannesburg, 831–905.

[22] Pacławski, K., and Fitzner, K., 2004, Kinetics of gold(III) chloride complex reduction using sulfur(IV), Metall. Mater. Trans. B, 35, 1071–1085.

DOI: https://doi.org/10.22146/ijc.49941