OPTIMATION OF TIME AND CATALYST/FEED RATIO IN CATALYTIC CRACKING OF WASTE PLASTICS FRACTION TO GASOLINE FRACTION USING Cr/NATURAL ZEOLITE CATALYST

https://doi.org/10.22146/ijc.21930

Wega Trisunaryanti(1*)

(1) Chemistry Department, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Yogyakarta
(*) Corresponding Author

Abstract


Optimation of time and catalyst/feed ratio in catalytic cracking of waste plastics fraction to gasoline fraction using Cr/Natural Zeolite catalyst has been studied.The natural zeolite was calcined by using nitrogen gas at 500 oC for 5 hours. The chromium supported on to the zeolite was prepared by ion exchange methode with Cr(NO3)3.9H2O solution with chromium/zeolite concentration of 1% (w/w). The zeolite samples were then calcined  with nitrogen gas at 500 oC for 2 hours, oxidyzed with oxygen gas and reduced with hydrogen at 400 oC for 2 hours. The characterization of the zeolite catalyst by means of Si/Al ratio by UV-Vis spectroscopy, acidity with pyridine vapour adsorption and Na, Ca and Cr contents by atomic adsorption spectroscopy (AAS). The catalyst activity test was carried out in the cracking process of waste plastics fraction with boiling point range of 150 - 250 °C (consisted of C12 - C16 hydrocarbons) at 450 oC for 30 min, 60 min and 90 min, and catalyst/feed ratio 1/1, 1/2, 1/3, ¼ (w/w). The result of catalyst activity test  showed  that  the maximum number  conversion of gasoline fraction (C5-C11) is 53,27% with relatively low coke formation using 1/3 catalyst/feed ratio and the cracking time of 60 min.. This  catalyst has  Si/Al ratio = 1,21 (w/w) , acidity = 0,16 mmol/g and Na content = 0,81%, Ca content = 0,15% and Cr content 0,24%.


Keywords


zeolite; catalytic cracking; gasoline; chromium

Full Text:

Full Text Pdf


References

[1] Suyartono dan Husaini, 1991, Buletin Pusat Pengembangan Teknologi Mineral (PPTM), Tinjauan Terhadap Kegiatan Penelitian Karakterisasi dan Pemanfaatan Zeolit Indonesia, Bandung.

[2] Saefudin, 1992, Pengaruh Temperatur Reduksi Terhadap Aktivitas Katalis Nikel/Zeolit Alam, Skripsi S-1 FMIPA UGM, Yogyakarta.

[3] Nurhadi, M., 1999, Pembuatan dan Karakterisasi Katalis Kromium-Zeolit Alam Untuk Perengkahan Fraksi Minyak Bumi, Tesis S-2, Program Pasca Sarjana, Universitas Gadjah Mada, Yogyakarta.

[4] Cahyono, B.L., 2000, Preparasi dan Karakterisasi Katalis Zeolit Alam Pengemban Kromium Untuk Proses Katalitik Pengolahan Sampah Plastik Menjadi Fraksi Bensin, Skripsi S-1, Jurusan Kimia, Fakultas Matematika dan Ilmu Pengetahuan Alam, Universitas Gadjah Mada, Yogyakarta.

[5] Arman, 1997, Analisis Berbagai Jenis Polimer dalam Plastik dengan Teknik Spektroskopi Infra merah Tranformasi Fouier (FTIR), Skripsi-S1, FMIPA-UGM, Yogyakarta.

[6] Adi, R., Cahyono, Eliyana, dan Rafika, R., 1998, Pembuatan Fraksi Bensin dari Sampah Plastik dengan Katalis Zeolit Alam, Laporan Penelitian Lomba Karya Inovatif dan Produktif, Jurusan Kimia, Fakultas Matematika dan Ilmu Pengetahuan Alam, Universitas Gadjah Mada, Yogyakarta.

[7] Wigiyatmo, 1995, Studi Daur Ulang Sampah Plastik, Skripsi S-1 FMIPA UGM, Yogyakarta.

[8] Gates, Katzer, and Schit, 1979, Chemistry of Catalytic Processes, 1st edition, McGraw-Hill Book Company, New York.



DOI: https://doi.org/10.22146/ijc.21930

Article Metrics

Abstract views : 2295 | views : 4029


Copyright (c) 2010 Indonesian Journal of Chemistry

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

 

Indonesian Journal of Chemistry (ISSN 1411-9420 /e-ISSN 2460-1578) - Chemistry Department, Universitas Gadjah Mada, Indonesia.

Web Analytics View The Statistics of Indones. J. Chem.